Heater is in the way.
Printable View
Heater is in the way.
a la Olivers attempt
http://i136.photobucket.com/albums/q...ure/nc0597.jpg
you ditch the heater and fit one of these under the dash!
http://cgi.ebay.co.uk/Powerful-200W-...1%7C240%3A1308
thats my plan anyway!:)
The ZX one appears to be different to the AX ones.
There is another bolt hold tab that is along the middle edge on the other side to the others (can't see it in pics). That lines up so I could bolt it to the gutter the bonnet sits in but thats not really tidy enough tbh.
Thinking about it, the spindle clamp to the scuttle take the weight on the left so if I just welded the rhd bracket as per my original plan, it should still let me pull it clear. Maybe. lol
^^ I had one of those before Bowman years ago in my red nova when I ran it stripped and they're crap!! lol
Utter crap.
Comming along tho dude.
And so on with the show!
Long hard think and several cups of tea later I made some more bracketry!!
http://img.photobucket.com/albums/v3...5-02-09002.jpg
To fit like so...
http://img.photobucket.com/albums/v3...5-02-09003.jpg
http://img.photobucket.com/albums/v3...5-02-09004.jpg
And proof i works :D
http://img.photobucket.com/albums/v3...5-02-09007.jpg
You can just make out in the pics that the motor and bracket does move slightly when it hits the end on the drivers side to come back. I'm fairly confident tho that when I do the bolt attaching it to the bracket up tight it will stop it.
The setup is completely removable and the bracket utilises an existing captive nut that the brake pedal assembly would have attached too. I'm gonna leave it all in for now while I finish up the wiring then when its out I'll chop off the excess metal and beef up the welds :D
Back onto the wiring and now I had some more connectors I finished off the single multiplugs for the headlights so they're easier to remove...
http://img.photobucket.com/albums/v3...5-02-09001.jpg
I then sussed out and chopped the rest of the wires in the bay to length then laid out the wires to the rear and they'll be nothing to chop out here if I don't want to but we'll see. Just need an assistant then I can get it all soldered up then just need to run the wires for a few switches, fuel pumps etc.
My "dumb" question today is my rad fan is mounted engine side - do I want it to suck theair through or blow back forward through the rad?
Fuuck my old boots that could have sunk the titanic are you sure the nova doesn't move around the wiper now lol nice to see you have over come though :thumb:Quote:
Originally Posted by The Simps
Might be a little overkill but it was easier to chop some of that down than chop into some sheet! lol
Don't dare even think about how much weight is in it tho...