My space framed nova with big power XE and sequential box

Too far gone, recieved the kit years ago now. I sent the tie bar brackets back, they replaced these but it wasnt until the other parts were on the car that i noticed how shoddy they were.

bummer, so pics? :d

lol Pics will come when i can be assed to upload them onto photo bucket.

go on then.... :d

im with sloth get it done felle there no where near enuff on here!!

pic's pic's pic's pic's pic's lol please:d

Post pics and ill update my thread :d


































With one pic lol

there are already some unseen pics in his photobucket :p yes its unlocked :d

A few update pics. Doesnt look like much but has taken me hours lol

Standard GM 5x110 hub

http://i227.photobucket.com/albums/d...8022010237.jpg

Countersink the holes and screw in some old studs

http://i227.photobucket.com/albums/d...8022010238.jpg

http://i227.photobucket.com/albums/d...8022010241.jpg

Cut studs off and tig weld in on both sides

http://i227.photobucket.com/albums/d...8022010240.jpg

http://i227.photobucket.com/albums/d...8022010247.jpg

Take a skim

http://i227.photobucket.com/albums/d...9022010248.jpg

http://i227.photobucket.com/albums/d...9022010249.jpg

I then re drilled on the miller to 5x100 and pushed splined studs in. These then had a small tack put on the back, notice there is a lip on the hub as well, this was put on to allow the disc to locate.

http://i227.photobucket.com/albums/d...1052010387.jpg

Said disc

http://i227.photobucket.com/albums/d...1052010383.jpg





Take a walden engineering lower arm

http://i227.photobucket.com/albums/d...5022010214.jpg

Chissel off as i want the tie bars to run backwards

http://i227.photobucket.com/albums/d...5022010223.jpg

http://i227.photobucket.com/albums/d...5022010226.jpg

Make a template out of cardboard for the tie bar bracket

http://i227.photobucket.com/albums/d...5022010220.jpg
Cut 4 out of 10's gauge steel and drill 25mm holes in to allow a stronger weld

http://i227.photobucket.com/albums/d...7022010229.jpg

The lower arm ball joit bearing carriers were welded on at differant and the wrong angles.

http://i227.photobucket.com/albums/d...2022010261.jpg

These were put in the miller at 16deg and machined off

http://i227.photobucket.com/albums/d...4032010294.jpg

http://i227.photobucket.com/albums/d...5032010296.jpg

These were bought from mcgill motorsport

http://i227.photobucket.com/albums/d...4022010275.jpg

The bearings supplied were a poor fit so i vibro etched them :d

http://i227.photobucket.com/albums/d...4022010278.jpg

These were then welded on here

http://i227.photobucket.com/albums/d...5032010298.jpg

All the original welds on the lower arms were then dug out on the miller and re welded

http://i227.photobucket.com/albums/d...1052010390.jpg