-
-
Not so good!
But could of been worse..
-
Whats going on there at the bottom of the turret like bit? Is it a huge plate?
Not that bad, i've seen much much worse.
-
That rust on the inner arch behind the arch lip i assume?
At least its fixable :)
-
you have balls of steel lol good work buddy i just hope it come out hoq you wish !!!
-
Fair play for doing it all yourself. I was planning on doing mine but i pussied out on it lol
Other side looks a top job, as does the rest of your work :thumb:
-
Jesus - I've only ever done that much cutting when i know full well ill never have to put it back together again...
-
ouch. at least youve had plenty of practice with the welder now
-
Shame about the rot but at least you're going the right way about it.
-
Yeah it's a big plate Benn, I can't remember it needing to be that big but was done over a year ago now.
Yeah the rust is behind the arch lip in the splash guard/tub and on the bit that sits in the middle of the sill. TBH I'm not really phased by it now, just cut it out ready to replace lol
Oddly enough the thing I most struggled with was removing the plastic tube that the tank filler breather goes through - I can't get it out?! :confused: Needs removing as there's rust around that too. (In the picture of the etch primer on the right)
