Looking good craig, you missed a bit under the washer bottlelol .
Printable View
Looking good craig, you missed a bit under the washer bottlelol .
Lend me some of your enthusiasm Craig lol
Thats where the washer bottle was... battery was meant to go there but it was too close to the dispack & strut brace, so will have to tack the washer bracket back in I expect.Quote:
Originally Posted by Jeff16v
Where do I send it? Paypal? :cool:Quote:
Originally Posted by Mike
looking good mate!! i love your exhaust!! the front end looks well mint.
keep it up:thumb:
Thanks Mike. Love your Avatar.
Heres the beauties I collected this morning, will be racing home to fit them like a school kid on his birthday!
http://i30.photobucket.com/albums/c3.../braided02.jpg
http://i30.photobucket.com/albums/c3.../braided01.jpg
Full front/Master cyl to rear braided lines.
That explains it:thumb:Quote:
Originally Posted by craig green
Those braided lines are yummy, expensive?
The braided brake lines werent too expensive actually. I had them made up by 'exact'. Think the guy used to work for Goodridge down here in Exeter.
My local rally supplier ordered them in. Full set of flexi's for the beam & calipers was £39. Just paid £40 for these 2. One is 3 metres long & the other 75cm. Not bad IMO.
Heres the progress of starting to fit them up.
Master cylinder end.
http://i30.photobucket.com/albums/c3...s/dscn2356.jpg
P-clipped down to boot floor, though its covered over.
http://i30.photobucket.com/albums/c3...s/DSCN2358.jpg
From a T-piece, copper brake pipe runs out to the flexi's under the boot floor.
http://i30.photobucket.com/albums/c3...s/dscn2357.jpg
Tonights plans are to screw more P-clips in & tuck the bias valve away on the A-pillar. (camera ran out of memory for the valve)
Im liking the lines :)
good work CG, kinda like the stealth performance thing going on - Hidden internal brake lines, etc. Very tidy ;)
i would have thought you'd put a gromit in the engine bay where the braided line passes through...