Pauls Nova Turbo Rebuild

Right finished off the fillering the other night, used some stopper last night to fill in the pin holes etc. Theyre now ready to primer, just got to DA again in 240gritt, scotch the inside, remove seat rails and nova gear stick. Then we can primer it!

Deadline for primer is set for next Thursday, so it'll be all go for me this week.

http://img.photobucket.com/albums/v1...a/DSC00078.jpg

http://img.photobucket.com/albums/v1...a/DSC00079.jpg

Supports for vent:

http://img.photobucket.com/albums/v1...a/DSC00080.jpg

http://img.photobucket.com/albums/v1...a/DSC00081.jpg

Til' next time

Paul

nice m8 good work there

Looking well Paul.
Vent looks very functional.

Quote:

---

Originally Posted by Paul

used some stopper last night to fill in the pin holes etc

---

What's stopper? I always seem to end up with the pinholes in my filler. :)

stopper is very fine filler. Basically you get the main shape out of the bodyfiller, then you do a final skim with stopper and that will get rid of any imperections. including pinholes, hairline cracks. You can also use it if you have a chip, instead of just feathering out the chip, that bit in the paint will always be slightly lower, so just used a tiny bit of stopper, then DA over the chip as normal.

Paul

Right went a bit stopper crazy tonight, had a dink in the door:

http://img.photobucket.com/albums/v1...a/DSC00084.jpg

Wasnt happy with the rear arches last time it was sprayed, little bit low, so on here too:

http://img.photobucket.com/albums/v1...a/DSC00083.jpg

Bonnet is now completely welded and welds grounded back, little bit of stopper here too:

http://img.photobucket.com/albums/v1...a/DSC00087.jpg

http://img.photobucket.com/albums/v1...a/DSC00086.jpg

Sealed all the arches, and joins in the quarters:

http://img.photobucket.com/albums/v1...a/DSC00089.jpg

Also plated this up, finished with brush sealer:

http://img.photobucket.com/albums/v1...a/DSC00085.jpg

And finally started to remove the seat rails:

http://img.photobucket.com/albums/v1...a/DSC00088.jpg

Paul

nice work there dude

Went to workshop today for a bit, and tagged the cage to the B pillars

http://img.photobucket.com/albums/v1...a/DSC00094.jpg

paul

yourgonna have to be carefull of the stopper around your bonnet pin holes !


lookin good tho .

Thats a good point, as youll see though most of that will disappear, so hopefully when the disc part of the pin is screwed to the bonnet it shouldnt matter.

Thanks for the comments

Paul