Printable View
When some one is made made up he can ride anything you like.. lolQuote:
Originally Posted by Jeff16v
Ben doesn't do gold, the ones on the oil lines are polish, but are a bit low quality. I'll get them changed.Quote:
Originally Posted by John
Thank you sir.Quote:
Originally Posted by Mark
Been watching this thread on MIG too.
I'm really impressed with the level of quality and detail on this car.
Thank you very much. I do try.
Stripped down my passenger door to fix the window runner, when i say fix i mean mod to clean the Audi handles. As i had to remove the rear runner, which ment the window wasn't running right/sitting right. So it couldn't be opened all the way and would some times jam.
So stripped the whole window/runner/trim down on the door. Had to cut the runner bar right down, but it still have the strength to hold the rubber and glass in right. Oil the rubbers up too and now the glass can be fully opened up and runs freely. Which is very nice. Then cleaned the door card up and fed the leather.
I stripped down the drivers side door today, did all the same things i did on the pass side, then found i had cut the runner thinking it was the pass one. Which ment i had cut the wrong side out, bugger. So with a little work and one of the bars from a CL kit, i remade it, got it all fitted and again oil the rubbers... Now the window works like a dream!
With the door card off, i could fit the sound deadening (sp?) pads in on the insides as i like the clunk when you close the door and it keeps the sound in/out too. Then used half a can of the Waxseal in the bottoms of the door and well all over tbh. Till it ran out the bottom. Refitted the card and gave it a good clean and fed the leather.. So that's two things off my list..lol
This morning when i when out to the car, i found a puddle of gear oil under the car.. Deep joy.
Looking under the car i could see it was dipping out of the pass side gear box seal.. so strip it all down, remove the seal, getting oil all over my face. Stripped the seal from my old F20 and got it all re fitted. Hope this one will be better. While i was in the wing i refitted my horn as my mot is on Wed.
While i was doing that Dan popped over and gave me a hand and changed my rocker cover gasket, as i hope that is what's been leaking oil down the front of the block. He fitted my nice set of shiney bolts too :)
Wheres the pics man?
I was at least expecting the army man to be climbing over the window runner lol lol
Haha didnt get chance to take any, ill make up for it.
Cant wait to see the pics benn.
lol I'll take a few in the next few days just for you.
Been cleaning lots...
Spoiler hadnt been flat and polished so i did it..lol
http://i6.photobucket.com/albums/y23...Paintwork9.jpg
http://i6.photobucket.com/albums/y23...aintwork10.jpg
Rebuffed the roof at the same time..
Dirty..
http://i6.photobucket.com/albums/y23...Paintwork7.jpg
After..
http://i6.photobucket.com/albums/y23...aintwork11.jpg
Found a few bits on my boot i wasn't happy with..
http://i6.photobucket.com/albums/y23...Paintwork5.jpg
Sanded,
http://i6.photobucket.com/albums/y23...Paintwork3.jpg
Polished,
http://i6.photobucket.com/albums/y23...Paintwork2.jpg
Oooooooooooooooo Shineeeeeeeeeeeyyyyyyyyyyyyyy
YOU at PV ??