Benn's on going build

Quote:

---

Originally Posted by LEWI007

Looks like good stuff that mate, might invest in some myself, where you get it from ?

---

Yeah it comes from the body shop, but any good body shop supplier should be able to get it for you, it's not cheap tho. We get it for £15 a bag, cause we buy about 30 bags in. You need a compressure to spray it tho, and a gun end attachment bit.

Quote:

---

Originally Posted by Iain

Are you planning on reconditioning the rear beam to go with the painted/chromed underside? Looks good so far

---

The beam was power coated when i got it, but it will come off when i do the boot floor, i'll get it stripped and rear power coated in gloss black.
Might chrome the tank straps tho.. hahah

Quote:

---

Originally Posted by Benn

Yeah it comes from the body shop, but any good body shop supplier should be able to get it for you, it's not cheap tho. We get it for £15 a bag, cause we buy about 30 bags in. You need a compressure to spray it tho, and a gun end attachment bit.

---

Well that crap waxoyl stuff i was buying before cost about a tenner and that went onto the compressor so it propably works the same way, except this just wasnt very good i thought it was the best gear !! .

Cheers though ill have a look about for some of this when i do mine again.

The end is special, as it connects to the bag. Waxoyl is ok for inside cavitys and bits. But under side its crap in my eyes.

I prefer Brush on type stuff myself then you can get it on nice and thick, easier.

Does the 3M stuff dry hard then Benn? I was always told to use waxoyl mixed with old engine oil so it stays tacky. Anything that dries hard can get a water trap or just chip away.

IIRC its like OEM stuff goes rubbery??

Nice work Benn

Seems like your slowly plodding along like me ATM lol

Waxoyl is crap, if you have to do something to the underside you get covered in the crap lol

That 3M stuff is probably the best stuff going tbh

the 3m stuff dries to a rubbery finish so its soft and bendy all most so it takes abuse very well, my front arches have no chips or any thing. Then paint over the top ahouls seal it in good. Edd i am, just spending alot of time with my new lady which in nicer than laying out in the cold lol

the 3m stuff dries to a rubbery finish so its soft and bendy all most so it takes abuse very well, my front arches have no chips or any thing. Then paint over the top ahouls seal it in good. Edd i am, just spending alot of time with my new lady which in nicer than laying out in the cold lol

Waxoyl is trash,good for inside doors and sills etc,but for undersealing properly some of the stuff like 3m's Raptor truck guard is awesome stuff,if you imagine OE is like rubber,this shiz is like polybush texture of underbody seals,its top stuff