Cheers Oli.
All comments welcome.
Printable View
Cheers Oli.
All comments welcome.
Keep up the good work mate !
very nice mate, can't wait to see the finished product, lots of moeny being spent too, should look the nuts, will stayed tuned for the rets of the project. keep up the good work!
Coochi
Some good work going on there!! I see there is extra plates on the inner arch is that for extra support or TIM WORM?;)
Plating is for tin worm. Damn!
Been cleaning out the back end ready for some seam sealer this afternoon.
Heres a few pics of the turrets as they are & some of the parts I will be fitting.
http://i30.photobucket.com/albums/c3...i_build005.jpg
http://i30.photobucket.com/albums/c3...i_build004.jpg
http://i30.photobucket.com/albums/c3...i_build007.jpg
The other side
http://i30.photobucket.com/albums/c3...i_build006.jpg
From outside
http://i30.photobucket.com/albums/c3...i_build008.jpg
Heres the Corsa hydraulic PAS rack. 2.5 turns lock to lock. (is that kwik)?
http://i30.photobucket.com/albums/c3...i_build001.jpg
With the 12v pump from Power steering services
http://i30.photobucket.com/albums/c3...i_build009.jpg
Painted V6 Vectra calipers, 16v rear calipers & new 288mm GM discs
http://i30.photobucket.com/albums/c3...i_build002.jpg
Currently got the Corsa GSi servo & pedal apart for cleaning & colour coding. (pics next week).
Fook, looks like you've had to plate quite a bit,Lol.
Good work tho, the rear turrets look top notch :)
The tin worm had bitten pretty bad!
Yeah it was under the boot floor that was worst. To be fair though it doesnt make sense to put in multiple small patches when a large one would look less patchy & make it easier.
Dash out today & tackling the new servo positioning.
Nice one craig.... the turrets look excellent.