Printable View
Engine out, cut off the drivers side passenger leg & turret from the bulkhead.
Weld on a whole leg & turret etc cut from a donor car. Pretty major, but in the grand scheme of things, the simplest & most effective repair you could do.
Under bonnet damage pics?
Thats a well easy fix!
Id keep it & repair TBH. ^As Craig says, a complete front corner would be far quicker/cheaper/easier to do then straigthen it all out.
id look at getting it on a jig at a body shop. it would pull straight.
Right some more pics as requested. I apologise for the picture quality as I only have a ****ty camera phone.
http://i25.photobucket.com/albums/c5...DSC00275-1.jpg
http://i25.photobucket.com/albums/c5...DSC00274-2.jpg
http://i25.photobucket.com/albums/c5...DSC00277-1.jpg
You can't really see anything on this one so you'll just have to take my word for it it. there is a little tear under here to.
http://i25.photobucket.com/albums/c5...DSC00276-1.jpg
Plan of action is to get my bosses dad to run through a quote for me and go from there. I will keep you posted.
That would pull straight out no problems.
i've seen people pull stuff like that out with a rope & a street light
You spying on me lolQuote:
Originally Posted by mowgli
Jesus, thats a really easy fix lol.
How is the rest of the shell before you jump in and repair it?
If you 100% happy with the rest of it, and there is no rust problems etc blar blar repair it.
If you have rusty arches of more patches than a montego, maybe its time to break it. Take the ID and use it on a better shell. Whalalaaaaaaaaa its still a GTE ;P lol Couple of Turret plates and your away.
"PNG do not condone Rexy's comments they are off his own opinion and should not be taken seriously"Quote:
Originally Posted by Rexy
lmfao
The rest of the shell is average I'd say. As you can see theres a patch infront of the turret that was done before I bought it and a patch in the boot. I repaired a hole in the sill before its mot which was done about a week before it was written off. The rear arches were done before I bought it but it was a poor effort as its started it bubble up on both sides. So that would have to be done aswell.
Anyone got any rough guestimations of how much its going to cost me so I don't get ripped off?