It's all in my WIP thread on page 22 and 23
BUT as said the ZX one works better then the AX.
Scott
Printable View
It's all in my WIP thread on page 22 and 23
BUT as said the ZX one works better then the AX.
Scott
awww well proud of ya
get the corsa wiper set up. plug a play then.
Nice work with the spot weld drilling but I would have got the grinder out and chopped it out personally lol
Just grind the other part of the battery flat like benn says. I tried drilling mineand its so piss thin you'll go through and end up having to weld holes up.
Ref wiper motor, run a ZX one. I made up a bracket for mine and it works fine...
http://img.photobucket.com/albums/v3...5-02-09002.jpg
http://img.photobucket.com/albums/v3...5-02-09003.jpg
http://img.photobucket.com/albums/v3...5-02-09004.jpg
http://img.photobucket.com/albums/v3...5-03-09005.jpg
http://img.photobucket.com/albums/v3...5-02-09007.jpg
It bolts into one of the holes for the old brake assembly. If you're still using the nova brake setup you could make it work with a longer bolt and a nut.
Hope this helps.
Thats swapping the motor over for the nova one btw.
Ah...So the ZX has a straight arm same as th AX, so in fact it's only the wiper arm thats going to increase the sweep of the blade!
Best look into a normal nova arm with long blade on then.
Scott
Yeah sits abit like mine in the AX bracket.Quote:
Originally Posted by The Simps
http://www.youtube.com/watch?v=Ld13tfp8tfQ
http://www.youtube.com/watch?v=Qdi6zmKjRxM
The arm is straight yeah. The arm I used was off a storm single wiper kit for a corsa.
I'm not sure what mines off, either an AX, or a rear wiper, not sure, but thinking about it you see you could get more sweep with a bent arm.
Scott
good work mate keep at it!
Thanks Simps and everybody for your help/comments.
Removed the rest of the firewall, wasn't too bad to remove:
http://iainel.co.uk/images/forums/NovaWIP2/259.JPG
Cut out hole by drivers turret:
http://iainel.co.uk/images/forums/NovaWIP2/260.JPG
http://iainel.co.uk/images/forums/NovaWIP2/261.JPG
Chopped out the manky bit of battery tray:
http://iainel.co.uk/images/forums/NovaWIP2/262.JPG
Cleaned up passenger turret:
http://iainel.co.uk/images/forums/NovaWIP2/263.JPG
The plates:
http://iainel.co.uk/images/forums/NovaWIP2/264.JPG
Bish:
http://iainel.co.uk/images/forums/NovaWIP2/265.JPG
Bash:
http://iainel.co.uk/images/forums/NovaWIP2/266.JPG
Bosh:
http://iainel.co.uk/images/forums/NovaWIP2/267.JPG
And, err, another bosh:
http://iainel.co.uk/images/forums/NovaWIP2/268.JPG
This is when I realised I might as well have just grinded the firewall as suggested above. lol I cut the remaining metal off as it offered no structural use at all and stitched it to the other layer:
http://iainel.co.uk/images/forums/NovaWIP2/269.JPG