I wondered where my cat had been all day. lolQuote:
Originally Posted by Razorjack
He's a spit of ours
Printable View
I wondered where my cat had been all day. lolQuote:
Originally Posted by Razorjack
He's a spit of ours
bah, long way to go, should of atleast tried it with a 240volt one,Quote:
Originally Posted by Razorjack
i hope it snatched and nearly cut your foot off, amateur lol
+ im slightly worried about the colour of your tressels lol
Humm Has been noted!:roll:Quote:
Originally Posted by General
getting then lads ??? how long this taken lol
The tressels belong to Alex's dad, and I really wouldn't want to be the one who calls him gay lol
Erm, well I collected the car in November last year... so nearly a year so far :D
I'll second that!Quote:
Originally Posted by Razorjack
3rded lolQuote:
Originally Posted by bump
Altthough I like him a lot, he's just as nuts with car trivia as i am.
omfg I touched the nova lol
I've put the 20XE wiring loom in place, most of the wires have connected up with no problems but I've got a couple left over which I'm not sure about. There's two on the gearbox side of the loom:
http://i13.photobucket.com/albums/a2...0012008043.jpg
http://i13.photobucket.com/albums/a2...0012008042.jpg
Does one of them connect to this?
http://i13.photobucket.com/albums/a2...0012008046.jpg
I've also got this coming off the engine which I'm not sure what it is. Doesn't appear to be a connector in the loom to suit it:
http://i13.photobucket.com/albums/a2...0012008052.jpg
Finally, next to this connector is a little tab (just to the right of the connector block) - when the C20XE loom was connected to the engine, it had a separate wire with a female spade connector which clipped onto the top; however the 20XE loom doesn't have this wire. Am I right in thinking its something like oil pressure?
http://i13.photobucket.com/albums/a2...0012008044.jpg
the one comming from the sump round connector with 2 pins, just cut it off, its a low oil level light i think lol
the bit you called the little tab is the water temp, the red plug thats in your hand is for the knock sensor im sure found under the inlet attched to the block, the other i aint to sure