Benn's on going build

Held a 4pot in place and can see why you need these discs with a huge off set...

Been trying to work out the discs for the 4pots. So measure everything get out the brake book...

http://i6.photobucket.com/albums/y23...n/IMG_8806.jpg

http://i6.photobucket.com/albums/y23...n/IMG_8807.jpg

Think i've found one that fits...

http://i6.photobucket.com/albums/y23...n/IMG_8808.jpg

Sadly this is as far as the can be fitted.. :(

http://i6.photobucket.com/albums/y23...n/IMG_8817.jpg

Ah can see why you need a huge offset on the discs..

http://i6.photobucket.com/albums/y23...n/IMG_8818.jpg

http://i6.photobucket.com/albums/y23...n/IMG_8819.jpg

Need to trim my hubs down tho then i can try fitting the discs

As the Rolling road is next weekend, the front needed to be raised up a little just incase..
Started off with 40mm of thread left showing..

http://i6.photobucket.com/albums/y23...n/IMG_8821.jpg

Wound it up a bit *vom* 50mm..

http://i6.photobucket.com/albums/y23...n/IMG_8823.jpg

After the RR i can wind it right down, haven't tested how low it will fully go.

Also i got all my interior bits back in too..

http://i6.photobucket.com/albums/y23...n/IMG_8812.jpg

http://i6.photobucket.com/albums/y23...n/IMG_8811.jpg

Got my new gear gator fitted too :) matches the seats...(black leather white stiching)

http://i6.photobucket.com/albums/y23...n/IMG_8815.jpg

Love the interior good work,

Poverty spec round knob!!

Did you ever fit the side mouldings for the seats I sold you Ben?

Round knob? What gear knob? What else would be fitted? IS a 4speed one too..lol And no haven't fitted them, but will soon.

Cheers 1992.

i want my car done, you make me sick lol

You love it. And get it finished and wheres my brace.... lol

your worse then a woman lol

Looks good!! Wheres the RR at?