-
ohhh might do, im not sure if i want vents or anything yet. lol dont want to cut a bonnet up and then change my mind.
http://1.bp.blogspot.com/-9jUnkUFnzR...s1600/boom.jpg
good now i have your attention...following lashup was done tonight :D
bit stainless pneumatic tube we have at work (70mm x 1mm) cut in half and used to cover the lashup that was the tops of the doors/wings
https://fbcdn-sphotos-a.akamaihd.net...28666266_n.jpg
https://fbcdn-sphotos-a.akamaihd.net...23154826_n.jpg
cut again to follow the lines
https://fbcdn-sphotos-a.akamaihd.net...10036622_n.jpg
better than this
https://fbcdn-sphotos-a.akamaihd.net...14601194_n.jpg
-
-
-
i want to see this finished :)
we did a similar thing with the tubeing on a datsun we did a while back
-
im trying to crack on. but people keep asking me to polish wheels for them and i could use the money to help finish it haha...its a win win lose situation
-
Finally some progress but now I know your names Dan I always think of this when I see any of your posts lol
http://www.youtube.com/watch?v=l2D3-...e_gdata_player
-
sorted out a deal on an XE block and crank which will fit my pistons :d so odds are my engine will be done much in advance of the shell :p could run it in, in a nice cav saloon :p
-
buy the cav bub you know it makes sense :)
-
Scrap the nova, use the money to buy a cav lol
-
nah...i like my BM...could XE that :o what a plan!
