i see it now
you posted just before me
Printable View
i see it now
you posted just before me
have you welded sheet over yet
Quote:
Originally Posted by cambridge
ok
its late and a little tired
cambridge>> is that to keep the weight down, or because the welded in cross members provide enough strength so that a sheet of metal is not needed????
defentlt goin to do it just when i have the balls to cut a big hole there
would scare the p**s out of me doing that, hello mr angle grinder :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted:
witht the fuel tank bein so close
just run it empty then wip it off, better to be safe than sorry, or you could just put like wet towels everywhere, altho taking it off is better :twisted:
you'll notice in the pic there are 2 straps just infront (under) of where the well was. they are the fuel tank holders. and you will also notice that there is a bit sticking out that i left, thats for the drivers side tank mount, i will be securing that to the strut brace once thats in its final place.
i cut it out with an air hacksaw thing. as the grinders were being used, and they wouldnt fit under the temp brace i fitted due to me cutting the back pannel off too.