E16se Torque Setting For Cylinder Head Bolts

Haven't got mine to hand but I'm pretty sure mine are done up to 60,60,60, afaik it hasn't spat any bolts out of the block yet though. I'll check it out when I take mine out to go over into the new shell thought just to make sure it's ok, head needs looking at anyway.

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

thanks mowgli thats clears that up off i go with torque wrench in hand lol

Quote:

---

Originally Posted by k reg nova

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

---

Are you serious??

Quote:

---

Originally Posted by k reg nova

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

---

I don't give the head gasket too long, as mine were bloody hard to do up even as far as 60,60,30 with a 2foot long torque wrench lol

Quote:

---

Originally Posted by k reg nova

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

---

i'm speechless

Quote:

---

Originally Posted by k reg nova

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

---

if it lasts 1000 miles I'll be impressed and give you an honorary engineering degree lol

Quote:

---

Originally Posted by k reg nova

I tightened mine up with a ratchet until they felt tight, no probs with it yet lol

bodge job or what.

---

well done. have a choclate biscuit

Air line FTWhttp://www.corsasport.co.uk/board/im...le/shocked.gif

a windy gun should only be used to dismantle stuff..............it should never even be used to tighten wheel bolts.