Printable View
Also modifyed the rear arches, so i removed the rear springs and shocks, put the wheels as far in as they went, and trimmed the arches accordingly. Hopefully i can run it nice and low without any problems (not as low as the below pic lol)
http://img.photobucket.com/albums/v3.../IMAGE_183.jpg
Keith
Get it that low on the road!! /\Lol
Looking good keith, looks a proper pro job :)
Awesome mate!
Looking sweet as.
**** the bed... tis like porn.. a masterpiece in the making; i hope ull keep this level of detail and patience all the way until the end mate.
looks good keith and very strong
can't wait to see the end product - not be long now......:)
Thats the plan mate. Hopefully Steven will leave the engine looking like new, so it will only be a matter of making sure everythings clean, painted/powdercoated when refitting. Hopefully i can source loads of stainless bolts to keep it all from rusting too.Quote:
Originally Posted by peester
Keith
this is s**t hot!
cant wait to see more now! looking awsome tho mate! good work
nice work there fella keep up the goodwork
Tiny update.
With Andy Bishop sorting out our intercoolers, its come to my attention that to enable us to get the most amount of room, we've all had to trim the front panel on our novas here:
Before
http://img.photobucket.com/albums/v3...007/before.jpg
Measuring
http://img.photobucket.com/albums/v3.../measuring.jpg
Cant go past these spot welds and the lip.
http://img.photobucket.com/albums/v3...measuring2.jpg
Yeehoo
http://img.photobucket.com/albums/v3...07/cutting.jpg
And were done....
http://img.photobucket.com/albums/v3...2007/after.jpg
Well not quite. I still need to remove about 3mm off the lower panel too, but ran out of cutting discs (i only had one and its tiny)
An update when i get that sorted. Just under a month now until our trip to england to get it dipped :)
Keith
Looking good - keep it up!
Joff