-
-
Looking good pal nice welds too.
-
Cheers mate I'm well proud of it. To think I was ready for giving up last week lol
Sent from my SM-G988B using Tapatalk
-
Impressive if that's your first attempt at making repair panels. I'd be well chuffed if I'd done that!
-
Honestly never done anything like that before lol, dont even have a metal bender so just used side of my workbench some vice grips and a hammer lol
Sent from my SM-G988B using Tapatalk
-
I've never had a bender too, hammer and vice works for most things. Recently bought a little vice mounted 5" or so bender for little brackets and such which is quite nice.
-
Yeah been meaning to invest in a vice that I can bolt to my bench.
Might get one during the week, make it easier to bend metal rather than using edge of my bench haha
Sent from my SM-G988B using Tapatalk
-
Drivers side flitch panel turned up today, time to attack that side on Sunday and ill need to do the inner wing as that's gone like the passenger side. So more fabrication on Sunday I thinkhttps://uploads.tapatalk-cdn.com/202...d17e467153.jpg
Sent from my SM-G988B using Tapatalk
-
Oh I've also ordered GM front panel today from COPE in Holland so hopefully have that soon
Sent from my SM-G988B using Tapatalk
-
Fairplay to you that's very impressive for a 1st timer!