Thanks, I still need to work out how I am going to fit a waste gate actuator but hey, I am sure I will work it out :)
Printable View
Thanks, I still need to work out how I am going to fit a waste gate actuator but hey, I am sure I will work it out :)
i thought you were going for an external waste gate?
good progress as usual. will have to pop over and have a look next time in in lincoln.
engine looks tidy mate. I still think you're going to have to run an external wastegate
I am a tight sod, I was going to but they dear and have little to no advantage on this kinda system/turbo. The original actuator will fit nicely when I extend it as I discovered today. Trust me guys its all in hand :)Quote:
Originally Posted by Dervy
cheers Dean you are welcome when ever pal!Quote:
Originally Posted by deanwilko
Well I have been working on her every night this week, just I don't really want to update until I have done enough to warrant it if that makes sense! But any way everything is going well! I think my Deadline of the 12th of July is still also in reach. I shall update soon chaps!
Dan
Back inner arch complete.
https://fbcdn-sphotos-a.akamaihd.net...20429046_n.jpg
https://fbcdn-sphotos-a.akamaihd.net...32745308_n.jpg
Drivers floor complete
https://fbcdn-sphotos-a.akamaihd.net...72564859_n.jpg
Stonechiped the front and rear O/s arches
https://fbcdn-sphotos-a.akamaihd.net...29776330_n.jpg
https://fbcdn-sphotos-a.akamaihd.net...55862837_n.jpg
did a bit of smoothing,
https://fbcdn-sphotos-a.akamaihd.net...47604605_n.jpg
and then me and the step dad went for a quick spin..
https://fbcdn-sphotos-a.akamaihd.net...19714649_n.jpg
Dan
Through some filler at my bay tonight :P
https://fbcdn-sphotos-a.akamaihd.net...09475197_n.jpg
And added the last skim on the O/s
https://fbcdn-sphotos-a.akamaihd.net...05072760_n.jpg
Shall hopefully do some more tomorrow night :)
Honie also poped round and gave me these, Top man :)
https://fbcdn-sphotos-a.akamaihd.net...32704508_n.jpg
I just need the fronts and some door cards now :)
Dan
Finished all the shaping on the O/s of the bay today, still needs rubbind down with 180, 320 and high build but it looking good :)
https://fbcdn-sphotos-a.akamaihd.net...27892135_n.jpg
And I have made a very good start on the N/s has a few low spots etc but I will sort them on Friday :)
https://fbcdn-sphotos-a.akamaihd.net...47712696_n.jpg
Dan