Does look stunning i must say!
Printable View
Does look stunning i must say!
Cheers Jay, will look good finished, well i hope.
Good progress.
Looks really good Benn, all come together quite quickly too!
Scott
benn will the tyres not rubb on them wires in the arch?
i smell abit of vag lol
will also be seein this at billing... :D
Cheers guys,
Martin i hope not, but they can be moved to clear if needs be.
Any update today Ben?
Did a trial fit of my ic, needed to cut the feet off the bottom.
http://img.photobucket.com/albums/v3...s/IMG_7728.jpg
Really well made, ally tubes welded on with hellicoiled mounts. That now lay in ruins on my garage floor...lol
http://img.photobucket.com/albums/v3...s/IMG_7729.jpg
http://img.photobucket.com/albums/v3...s/IMG_7730.jpg
With it sitting in place i could see the sides on the front pannel needed trimming.
http://img.photobucket.com/albums/v3...s/IMG_7731.jpg
Trimmed back, not as neat as can be. But done wit the tools i have at home.
http://img.photobucket.com/albums/v3...s/IMG_7732.jpg
Silicone elbow( all gloss back) on and sitting in place.
http://img.photobucket.com/albums/v3...s/IMG_7734.jpg
Dv bit in place.
http://img.photobucket.com/albums/v3...s/IMG_7735.jpg
Rooms ok, so started mocking up the inlet elbow.
http://img.photobucket.com/albums/v3...s/IMG_7736.jpg
http://img.photobucket.com/albums/v3...s/IMG_7738.jpg
Had to make a bit more clearance.
http://img.photobucket.com/albums/v3...s/IMG_7739.jpg
Picked up a 2" 2meter tube of stainless..
http://img.photobucket.com/albums/v3...s/IMG_7742.jpg
Measure and cut to get..
http://img.photobucket.com/albums/v3...s/IMG_7743.jpg
Started sanding it...
http://img.photobucket.com/albums/v3...s/IMG_7808.jpg
Ten started polishing it up..
http://img.photobucket.com/albums/v3...s/IMG_7806.jpg
http://img.photobucket.com/albums/v3...s/IMG_7809.jpg
Bit better..
http://img.photobucket.com/albums/v3...s/IMG_7807.jpg
Finished bar a wax.
http://img.photobucket.com/albums/v3...s/IMG_7814.jpg
http://img.photobucket.com/albums/v3...s/IMG_7815.jpg
Water pipe looks much the same too.
Needs a good few coats of..
http://img.photobucket.com/albums/v3...s/IMG_7784.jpg
Started to workout where and run the boost lines.
http://img.photobucket.com/albums/v3...s/IMG_7740.jpg
http://img.photobucket.com/albums/v3...s/IMG_7741.jpg
Cut to today,
Pete wasnt happy with my servo line, so started to make me up a new bit..
http://img.photobucket.com/albums/v3...s/IMG_7747.jpg
He had a think..
http://img.photobucket.com/albums/v3...s/IMG_7761.jpg