Doesnt look like the elbows are going to fit unless the cooler sits back behind the tabs at each end on the front panel?
Ive had to cut mine off and its still very tight.
Printable View
Doesnt look like the elbows are going to fit unless the cooler sits back behind the tabs at each end on the front panel?
Ive had to cut mine off and its still very tight.
What?
I assume your using 90degree elbows? Ive had to cut of the tabs (marked red) and its still very tight. Unless the hoses will sit behind them? Cooler im using looks the same width
http://i124.photobucket.com/albums/p...Untitled-1.jpg
Looking good bud!
As Rich says tho it will be very tight to get an elbow in there! If you know an ally welder can they not put a bend on there for you?
Oh, you might want to put some more wax on your front panel before you put too many bits on :p
looking good benn,
i like your attension to detail especialy on those innerwings and slam panel the paintwork looks swell wish mine would look as good as this.
keep up the good work mate.
damen.:thumb:
where's that intercooler from benn?
I'm planning on getting the ends of the ic trimmed down and then 90o elbows welded on, this should clean the front pannel.Quote:
Originally Posted by Rich
See above, and only one coat of wax one it...Quote:
Originally Posted by The Simps
Cheers dude, :)Quote:
Originally Posted by damen
Ebay, is a uni small fit, want me too look for the link?Quote:
Originally Posted by childsgte
is it one of them tx autosport ones? did like the look of them but didnt think theyd be any good compared to a forge one.
what do you think of the quality? what type of power you going to be running through it?
bruce
I think its is the same yeah, as it looks it in the pic and the sizes are the same.
Quality is 100%, really well and nicely welded, would tell anyone to get one.
For 70-80 you couldnt get better and better value for money.
Oh any one with the turbo connections number in the pics?