Edd's Nova Sport

Quote:

---

Originally Posted by Novasport

Edd, the oil sender is a later one which has a multiplug. The correct one has a stud & 6mm male blade. Great work BTW, nice to see it coming along.
Re the seatbelts, I was going to run four point harnesses. There is an extra hole drilled on each side of the rear seat pan for the eye to go through and fit to a strengthening plate.

---

I dont really want to fit harnesses so ii hoping there will be a way round it.

Seeing i have the wrong oil sender, (great payed 50 quid for it !!!) is that still going to work ?

in the pic below of the one i have, it has stud and a plug, and i have 3 wires any idea to which one goes to the stud ? and the plug ?

http://i499.photobucket.com/albums/r...S/SAM_0559.jpg

http://i499.photobucket.com/albums/r...S/SAM_0561.jpg

i think one is deffo the charge light that goes on the alternator, the one with the ring i think ? Do 2 wires go to the sender ?

Quote:

---

Originally Posted by Mark Sparks

Looking fantastic mate :thumb: , not to sound or picky anything like that just noticed but that rear bumper is the wrong one i know coz i did the same lol it should be smooth at the bottom.
And will the rear decal fit ok now the spoiler is fitted?
As for the seat belt could you not take the plastic out put it on the bar first and some how thread it between the cage? it does look tight tho:eek:
I wouldnt cut it coz that means welding it in the car with the carpet fitted would be a nightmare if it cought fire.

---

Cheers, i know about the bumper, REALLY REALLY want the correct one but cant find a new or as new one anywhere :(.

There is no chance of fitting the seat belt bar behind the cage, no chance lol think i have to look into it further.

The one in the midle goes to the altonater the other 2 go to the snder. Cant see why it wouldnt work mate just make sure by testing it with a oil preasure tester.

Blue with yellow tracer is the signal wire & brown is earth. Just checked early and late and its the same for both so your sender might be off something else like an XE. Either that or the earth stud is not used and the wires both go the the plug.
Do you have a part number for it? I can check on EPC then

**Edit** can you clean the mucky finger prints off the firewall please ;) lol

THIS is the sender iv got, Part Number: 90337695N

I don't have a brown wire tho.

I did notice the finger prints !! lol nightmare keeping it all clean tbh lol

26 switch, Oil Pressure (2 Connections)12s, 12st, 13s, 13sb, C14se, E16se
Chassis range -J4999999
Part number 90040918 12 52 5581

27 switch, Oil Pressure (2 Connections)12s, 12st, 12nv, E12gv, 13s, E16se, C16se
Chassis range K4000001-
Part number 90337695 12 52 563

26 is the correct one but EPC lists both as '2 connections' so should still work.

Sorry, both wire are blue/yellow. I have just been out to the garage and checked mine. Read wiring diagram which shows a wire going to earth and I wrongly presumed it to be a brown earth wire.

Nice one for looking, the ring on the stud and the other to the plug then I think ?

Top work Edd ;)

Nick.

Find a plug down the breakers & put it on the loom?

Nice update Ted, sorry we havent caught up whilst you were off.

The Nova is looking great mate, great project, really liking it :thumb:

What stuff did you use for the heated screen? Where did you get it from?