Alloys and ofsets

right ive just got a set of 15" masitalys(sp)

these ones..


http://i23.photobucket.com/albums/b3...000_0001-4.jpg

There 7J x15 and et35 am i going to need spacers or anything, or arch work to fit these?


cheers martin

et35 means they'll stick out from the car, so no need for spacers :)

You may have outer arch clearance issues though, especially with a 7" wide wheel.

[edit] I ran et38 6.5" wide Oz wheels on my old hatch. Needed rolled arches on the back and the fronts were mightily close. That was lowered 60F/50R on spax stuff.

I think Ash's black TD wheels are 7" wide, and et38 - they'll sit 3mm further in than yours. I think he had Ok clearance though, again will rolled arches.

well i had 17" J7 Et35 on the saloon, and they did not even fit, on a hatch you have no chance lol

oh dear.. i maye have to try them tomora, if not i'l refurb and sell on..

I think 35 is pushing it. My OZ's are 38 and you need to remove ALL the lip on the back to get them on lol

You'll need arch work 100%.
Et35 and 7j is asking for trouble,Lol.

Rear arch rolling might sort it

Quote:

---

Originally Posted by Lee

I think 35 is pushing it. My OZ's are 38 and you need to remove ALL the lip on the back to get them on lol

---

Meh its mostly rusted away anyhow

pends wat tyres u run too

if u run stretched rubber you might get away with it

what size tyres would i need to get the "stretched" afect? my mates got his own tyre place, i could "borrow" a trye see if it works

well 205's dont fit lol