h&h ignition module wiring help

Hi. just come to wire my ignition module/ coil up.Dont know were the 3 wires go.
heres some pics
http://i339.photobucket.com/albums/n..._47_19_Pro.jpg
http://i339.photobucket.com/albums/n..._47_33_Pro.jpg
http://i339.photobucket.com/albums/n..._47_24_Pro.jpg


any help would be grate.

This may help:
http://www.pngclub.com/forum/showthr...=1#post1772524

I found that on google.But could i make head or tails of it. I know red to + side. black ignition? Thought the brown would - side of coil but cant seem to get a spark

please read important fitment note electronic systems only :
this distributor replaces all electronic & points systems

the loom supplied with the distributor connects directly to the distributor via 3 pin plug, ignition module via 7 pin plug, & the ht coil (supplied).

distributor wiring is as follows:
red – positive (+) side of ht coil.
black – negative (-) side of ht coil
brown - ground

this system requires a 12volt non ballast ignition from the vehicle wiring loom fed to the positive side of the new ht coil. If there is a rev counter wire on the negative side of the existing ht coil this will need to be re-connected to the negative side of the new ht coil.

thanks mate will give it ago :thumb:

That's straight from H&H and mine fired straight up like that.