Printable View
Been recommended to remove the oil gallery bolts to clean the block out thoroughly. I assume these are the allen key headed bolts behind the waterpump and behind the flywheel.
They seem quite tight and I'm a little worried about rounding them off, do they usually come out easily? Are they a special size?
Cheers!
not a special size, but they are loctited in very tight
OK cheers, just a bit worried as a size 7 fitted nicely but looked as if it was going to round it off when I applied pressure.
Id leave them tbh
You'd just dump the engine in without stripping it down at all though lol
Seems to work fine for me????? lol lol
Mines 180brake remember ;) lol
I'll buy your perfect engine when you break it then lol
Come remove it tomorrow night
As suspected it has rounded off, any suggestions?
http://iainel.co.uk/images/forums/OilGalleryBolt.JPG
either leave it, or get a drill into it followed by a stud extractor