Printable View
anyone shed some light on what might cause these problems and possible fixes for them???
31Engine RPM signal (crankshaft sensor)No signal
66Carbon Monoxide (CO) potentiometerHigh voltage
73Air Flow Sensor (AFS)Low voltage
94Hall Effect Switch (HES)High voltage
31, is the crank sensor plugged in? if so duff crank sensor, i'd say all the others are concerned with the plugs being disconnected and re-connected, with the ignition on.
which is the crank sensor?
Don't forget if you flashed the codes out with the engine not running you always get code 31.
Check the wiring on the lambda sensor for code 66
Check AFM wiring for code 73
and check wiring to the little 3 pin plug ontop of the dizzy and to the coil for 94
crank sensor is on the front of the block, next to the front engine mount, held on by a 10mm bolt ;)
cleared all apart from 94
checked and cleaned all connections. Still shows fault :confused:
hall effect showed up on my xe changed the distributor was fine after that
这是新加的空白文章1，可以在UBB可视化编辑器中，添加和修改文章内容。
^^
This is a new article added to a blank, in UBB visual editor, add and modify content of the article.
Wtf??
When I investigated the hall effect switch on Max boost it was something to do with ABS warning IIRC