timing marks 1.4 /1.3 engine

[dan23]

on the 1.4 the crankpulley has a notch that is meant to be 10 degrees btdc

if i replace the pulley with the one off the 1.3 engine that has 1 marl an set the mark to tdc will the timing be correct ?

[garyc]

1.3 timing mark is 10 deg btdc

[dan23]

so there is only 1 timing mark on the 1.3 pulley an it should be at 10 degrees btdc ?
i am sure mine is set to tdc can someone explain how i can set it 10 degrees btdc without taking head off ?

[garyc]

it should already be fixed at 10 degrees.

[dan23]

long story i took the head off the 1.4 an swapped it for a 1.3 head

i think i got the pulleyys mixed up as i am sure it only had 1 mark on it an if i remember correct i set it at tdc