Turbo Technics T34.55, 360 bearing, cut back blades, -31 actuator

[Jonlem]

Due to myself and Gav not building the drag car anymore we do not need the turbo we purchased for it.

It is a Turbo Technics Cosworth T34 with a .55 exhaust housing.

This was a new unit approx 18 months ago and has done very little work.

It comes with a -31 actuator

If you want a bulletproof turbo capable of between 330 and 400hp on the right engine then this is ideal.

We paid £450 for it but we'll take £400 to see it gone now.

NO Offers, can take to PV

http://img.photobucket.com/albums/v306/Jatec/DSC02899.jpg
http://img.photobucket.com/albums/v306/Jatec/DSC02898.jpg
http://img.photobucket.com/albums/v306/Jatec/DSC02897.jpg
http://img.photobucket.com/albums/v306/Jatec/DSC02900.jpg

[garethcolley]

would this run with standard ECU or would you need engine management and a full re map?

[Jonlem]

We were going to be using Evo 5 chips, my mate runs one on phase 3.5.

Obviously with 1.25 bar held on this turbo its going to be making a LOT more power than a kkk would at that level.

A friend of mine runs the same turbo on his 3 door cossy, peaks at 2.2 bar, holds 1.8 bar and has done for 5 years and 30k miles.

[Paul]

i would be int4erested if it werent for the cut back blades

[Jonlem]

Whats the issue ?

Its however Turbo Technics supply them which as far as I know is with cut back blades, I'm sure if they don't work then they wouldn't use it so I'll run it by them for you if you want ?