View Full Version : actuators
ive got a t3 cossie 2wd turbo and need an acuator ive been looking on burtonpower site and there got a few but with different psi ratings whats the best one too get as just looking to run 300 brake or as near as i can get too it the psi ratings on burtons site are 8-15 an 12-20 then 20-28 plus i need the bracket aswell to mount it on as not got one
Dicko's
03-06-08, 02:43 PM
ive got a t3 cossie 2wd turbo and need an acuator ive been looking on burtonpower site and there got a few but with different psi ratings whats the best one too get as just looking to run 300 brake or as near as i can get too it the psi ratings on burtons site are 8-15 an 12-20 then 20-28 plus i need the bracket aswell to mount it on as not got one
you want a -31 mate actuator, if its for a cossie turbo anyway, theyre good enough for 350bhp ish,
Sarah
Austin_Nova16
03-06-08, 03:17 PM
Yeah, get yourself a -31 off ebay...usually pick them up for a tenner :thumb:
Dicko's
03-06-08, 04:26 PM
a tenner, wish id bought mine for that much, got a -31 anodised for £45 at national day grrr
Sold our 2nd hand one a few months back for £25!
I'm running the same Turbo on mine, i had a fairly new (MotorSport Development) -31 actuator on my K16 so modded that to fit but found that even without any preload on it it was boosting to much (over boosting and holding higher than i wanted), fitted the origional actuator (also a -31 ?) that came with the T3 and it was fine.
What management you running, Phase 2, Evo5 or aftermarket ?
r1ch im going for a phase 2 chip set so a standard -31 actuator will be ok
so you mean you have a cossie turbo on your c20let and not a cossowrth right? initialy thought you had a cossoworth and wanted an actuator.
does the turbo have the actuator bracket cast into the compressor housing?
i'd prob go for a -31 actuator but one of the better billet alloy ones as you can change the springs for diffarent boost pressures. think i seen them around the £70 mark brand new on ebay.
ive never seen a -31 actuator go for a tenner, more like the £30 mark s/h
yeah its a c20let with a t3 thats all i keep finding is ones for around 70 and 100 quid thats for a billet one
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.