View Full Version : Anyone interested in having parts made?
Philsutton
22-05-08, 12:06 PM
In a few weeks all the students will be gone for four months and its going to get rather dead at work and since Ive got a workshop with pretty much everything I could ever need in was thinking about making up some parts uber cheap.
I.e lowering brackets for conversions, and some adaptors so that you can run a fuel pressure gauge on the standard fuel rail ect... mainly things that take a week to fabricate lol
Just wondered if anyone was interested and if there was anything people are after really.
Yeah! I'd happily take a few sets of 2.0 Conversion Mounts
Where do you work mate out of interest?
what about making a few sets of adjustable tiebars?
meritlover
22-05-08, 07:22 PM
how about panel beating me a spare floor pan for a nova? or make me the small pin that holds the boot lifting strut onto the balljoint on the back door?
or some plasma cut me some con-rods out of stock 1/2" plate. il file them to shape ;)
thanks,
meritlover
Rose jointed tie bar brackets please
Make me a bull bar for the Frontera :)
Make me a bull bar for the Nova ;)
twistysnovagte
22-05-08, 08:04 PM
a new shell:p
i need a new belend can you makeme one asap? :D
i need a new belend can you makeme one asap? :D
No, you have to REMOVE the bellend! Jeeze, dont you know anything? :wtf:
i did but i lost it.. and i need to put it back on so i can sell..
Jeff16v
22-05-08, 08:29 PM
2.5inch polished stainless exhaust with outwardly rolled rear box please:thumb:
how cheep are we talking
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.