Fitting skirts without drilling holes

[Adam]

I have brand new skirt clips to use, and the skirts all painted up.

Anyone fitted the clips with just tigerseal on the back of them? Did it hold?

I dont want to drill if i can help it because
A-You cant remove drilled holes easily(incase i dont like the skirted look lol)
B-More chance for rust
C-Tricky getting the holes in the right place

:)

[novacabrio]

fit the clips to the skirts and use tiger seal

[Adam]

That was the plan
But will it hold? Lol

Trying to think of someway of holding the skirts still for 24hours whilst it dries

[General Baxter]

a 60mm lowered nova, is a perfect height to use a halfords 400ml spray can, to rest the skirts on, whilst the sealer is setting lol

[Adam]

lol lol lol

[General Baxter]

baxters top tip of the week :D

[Leeboo]

Well it really isn't hard to get the holes in the right place, even I done it lol . But yeah given your other reasons...

Tigerseal would prob hold.

Or throw Keith Robinson a PM, I think hes gonna use windscreen sealant on his for the Turbo???

G/luck

[novacabrio]

use masking tape while it dries thats what bodyshops do

[Adam]

I'll see how i get on

[DW-Nova]

Using tigerseal will definetley hold the skirts on!! really you dont need to worry about them not sticking! give the sills a good clean and a whipe with some thinners then thoroughly dry them and apply a line of tigerseal to the skirts and slowly line them up and then apply, to keep them in place while it sets just use some strong tape or a few g-clamps, once set it's mega strong stuff so dont worry about them falling off but do worry about getting them back of if you dont like them!

[Adam]

but do worry about getting them back of if you dont like them!
Yup, that is a bit of a worry lol lol