View Full Version : cam pulley photo
General Baxter
28-04-08, 07:33 PM
small block 8v
can some on put there car to TDC and take a photo of the pulley on the timing marks, and give some referance on the engine on where it sits,
as i think im a tooth out, and i have no timming marks lol
stevenf
28-04-08, 07:34 PM
is this for the 1.2
General Baxter
28-04-08, 07:34 PM
well its a 1.3 ish top end
stevenf
28-04-08, 07:36 PM
sound will go outside and see if the pullys still move. if it does i will gets pics up asap
stevenf
28-04-08, 07:52 PM
i couldnt move the pullys but took pictures of the timing marks for you. just uploading them to the computer now
stevenf
28-04-08, 08:04 PM
is it both timing marks you need or just the one?
stevenf
28-04-08, 08:07 PM
well here is teh pic for the bottom pulley. as you can see the timing mark is arrowed. it sits just to the left of the bolt
http://http://i218.photobucket.com/albums/cc80/stevenf86/nova%202/generalbaxter006-1.jpg
hope this is of some help
General Baxter
28-04-08, 08:11 PM
wrong pulley lol
stevenf
28-04-08, 08:15 PM
what one you wanting? the top one?
General Baxter
28-04-08, 08:16 PM
cam lol
iirc the cam pulley notch points straight up
stevenf
28-04-08, 08:18 PM
right got the pics now lol
stevenf
28-04-08, 08:25 PM
here we go the timing marks are in line with the fourth raised line on the rocker cover. here is the pic
http://http://i218.photobucket.com/albums/cc80/stevenf86/nova%202/009-1.jpg
stevenf
28-04-08, 08:25 PM
hope this is ok this time lol
General Baxter
28-04-08, 08:29 PM
iirc the cam pulley notch points straight up
now does it point stright up, as the head sits on the piss a little, its it inline with the head,
so the bottom crank its virtical and the cam its about 10 degrees
or do they both point stight up lol
General Baxter
28-04-08, 08:33 PM
red or blue lol
all tho its not at that angle maybe 1 tooth out lol
http://i11.photobucket.com/albums/a191/baxters83/cam.jpg
stevenf
28-04-08, 08:48 PM
if you look at the two pics i took both were taken with the engine upright as it would be sitting in the car.
WTF are you on Baxter? Confusing me lol
The crank one points down to the cutout on the oil pump(on the sprocket, NOT the pully)
The cam one points straight up vertical.
mulletor
01-05-08, 12:56 PM
dousnt the top mark point straight up??? i think it does
as in smack bang in the middle.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.