walshc
13-03-08, 03:53 AM
First of all, i`ll take no blame for damages,burns general co*k up-age if you decide to follow my guide, use at own risk lol
Well i tinted my headlamps recently, so thought i`d do a bit of a guide...
First thing you want to do is remove the whole headlamp unit from the car, remove bulbs and give it a good clean, make sure there is no moss/mould left as it will stink your oven out lol
Then place unit in the middle of the oven and let it cook on gas mark 7/200 degrees C for 8 minutes (adjust time accordingly for fan assisted ovens) or untill the sealent has softend enough
http://img217.imageshack.us/img217/878/imagelb7.jpg (http://imageshack.us)
Carefully using appropriate (sp?) protective hand wear, prise the glass away from the unit. My choice of prising tool was a little girly pair of scissors lol dont dis them, as the PIMP :cool:
http://img148.imageshack.us/img148/8902/image01es7.jpg (http://imageshack.us)
I say carefully, as accidents can and do happen...
ooops! lol
http://img217.imageshack.us/img217/2678/image03tm0.jpg (http://imageshack.us)
I reccomend starting with the corners, and gently running your prising tool down the seem
Successfull prise-age will have you something like this
http://img156.imageshack.us/img156/7121/image02fo2.jpg (http://imageshack.us)
Next, you want to get all of the sealant off the glass and unit, mask off the areas you dont want to spray and sand the rest down
http://img156.imageshack.us/img156/3916/image04cf4.jpg (http://imageshack.us)
Well i tinted my headlamps recently, so thought i`d do a bit of a guide...
First thing you want to do is remove the whole headlamp unit from the car, remove bulbs and give it a good clean, make sure there is no moss/mould left as it will stink your oven out lol
Then place unit in the middle of the oven and let it cook on gas mark 7/200 degrees C for 8 minutes (adjust time accordingly for fan assisted ovens) or untill the sealent has softend enough
http://img217.imageshack.us/img217/878/imagelb7.jpg (http://imageshack.us)
Carefully using appropriate (sp?) protective hand wear, prise the glass away from the unit. My choice of prising tool was a little girly pair of scissors lol dont dis them, as the PIMP :cool:
http://img148.imageshack.us/img148/8902/image01es7.jpg (http://imageshack.us)
I say carefully, as accidents can and do happen...
ooops! lol
http://img217.imageshack.us/img217/2678/image03tm0.jpg (http://imageshack.us)
I reccomend starting with the corners, and gently running your prising tool down the seem
Successfull prise-age will have you something like this
http://img156.imageshack.us/img156/7121/image02fo2.jpg (http://imageshack.us)
Next, you want to get all of the sealant off the glass and unit, mask off the areas you dont want to spray and sand the rest down
http://img156.imageshack.us/img156/3916/image04cf4.jpg (http://imageshack.us)