Carbs

[hoody_c20xe]

Hey Guys.
Need a bit of help!! :confused: I have got a 20xe in gte shell and just bought some R1 bike carbs already on xe inlet and a few other bits included (Throttle cable,clips etc). Are they easy to fit and do they take much setting up.

OR

is there any 1 in Derbyshire people can recomend that will do the job????

Thanks:thumb:

[djbrowney]

is ok havin the carbs but have you thought about what you are going to do about ignition before you even put the carbs on ?

[hoody_c20xe]

No. im quite new to all this:confused: so not really sure where to start. Any advice or recomendations would be a great help.!!

[BenNova]

get on the phone to JNC racing 01159461105 - They are in Long Eaton if you know where that is? They give free advice and know a lot about novas funnily enough, i dont think they can set the carbs up, but they can probably help with everyhing else and i dare say point you in the right direction.

[hoody_c20xe]

cheers all :thumb: :thumb:

[Adam]

You will need an old big block 1.6/1.8 carb distributor and ignition module/coil, to control the ignition side of things.
Theres a Total Vauxhall Mag how to guide on there website.