View Full Version : Problems removing my mk1 dash
20SEHnova
02-02-08, 02:34 PM
just half way through now following my haynes manual. Problem is the 2 screws at either end of the dash have had theyre tool profile rounded out and now i cant seem to be able to get them out at all :/. Any suggestions? many thanks
JSeymour
02-02-08, 03:48 PM
hit a bigger size bit in there.
Welsh Dan
02-02-08, 04:13 PM
Screw extractors?
Drill the heads off then use mole grips to get them out once the dash is out?
20SEHnova
02-02-08, 05:26 PM
sorted :) Thanks lads used both methods in the end and the dash is out. success :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.