View Full Version : Uprated Bearings
neiloakley
19-07-02, 08:50 AM
Where can i get some uprated bearings? Cos i did 138 in my nova and as i was slowing down i lost the back end. Stopped and the back wheel was loose, jacked it up and all the bearings fell out. Examined it further when i got home and i had welded the inner race onto the stub axle.
Please help cos i cant go above 90 now
Ste_Nova
19-07-02, 12:29 PM
std ones are ok...... i replaced mine before doing my 16v conversion and do 140+ all the time
what size wheels you runin ste?
i have no prob either with standard new ones since my 16v went in.
But a while back on my gte i had 17's and with a lot of driven on crap roads had to change them fairly often :?
lol @ ste,
i do 140+ all the time
theres nothing like incriminating yourself :D
Benji - thats rpm not mph and so un-incriminating for any police types viewing...
:D
...which is about 4 mph! :o
neil that happens when you overtighten the bearing putting it back on, the little bugger colapses at high speeds when u least expect it to!!
neiloakley
19-07-02, 11:58 PM
nice one. cheers dicko. I'll actually use a torque wrench next time.
as for doing 140! What ste was saying was he regulary does 70mph. But he just multiplied it by 2 to sound dead ard and the + was just a typing error. Should have read
"standard ones are fine. i do 70 all the time (except obviously when in a thirty zone)"
dave.gsi
20-07-02, 12:14 AM
lol......
aren't the nuts supposed to be done up finger tight???? then when u put the wheel back on it should have the slightest bit of movement front to back?
neiloakley
20-07-02, 12:16 AM
nah i think there is actually a setting in the front of the haynes manual for them but that is all the way downstairs and i cant be bothered to actually go and look at it.
both wrong, wot u do is tighten them up til they feel a little tight with a spanner, then keep slackenin them off til u can just about move the metal washer with a thin screwdriver and a little pressure!!
you do em up until you can just move the thrust washer from side to side with a screwdriver.
also my front left bearing has gone AGAIN! poxy thing, that can wait till i can be botherd
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.