View Full Version : Just starting out any advice with shafts to use with c20xe & f20??
Anyone willing to share some experience?:roll:
www.valvers.com (http://www.valvers.com)
alternatively do a search or google chris astley motorsport.
alternatively do a search
I am learning from the master!lol
GRUNT 16V
23-01-08, 12:26 PM
cav mk2 inner cvs with GTE shafts work fine!!!!!!!!
^ what he said.
I've run over 340hp without any breakages :)
Just make sure you use new cv's as you can't expect 200k old nova ones to handle the power ;)
Chris Astley can supply the cv's (or any local motor factor)
Ian @ Eurorallye usually keeps the shafts iirc.
FYI the inner cv's accept a 22 spline driveshaft, if you look in the book at your motor factors it will list all the details you need so that you get the correct cv's
nice 1 jonlem, any ideas where i get hubs from?
Just use the ones on the car as you use normal nova outer cv's, if you want to replace the outer cv's they are nova gte/ nova td fitment, the splines on the cv dont match up with the driveshaft if you use sr or lower models ones iirc. Its been a while since I used a set now, change the bearing for safety reasons.
There isn't much else to them tbh, a ?40 mount kit off ebay and you've basically got everything to drop a xe in a nova, you can build them so cheaply If you want to :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.