brake lines?

[greg1.4]

right here goes..

i am running a bias pedal box with 2 resovoirs, a hydraulic handbrake and rear drums..

can i run with my standard nova handbrake cable aswell as a hydraulic one?

how do i run the lines? i have no idea?

if someone could explain where the lines go it would be good..from the pedal box to where..i take it one cylinder in pedal box will be for front brakes and the other for rear..

on the rear brakes i want a line or two if need be coming from pedal box into handbrake then going to back brakes..whats the easiest and tidiest way to run the lines?

cheers

Greg

[R1CH]

Aye front cylinder, just have 1 line coming out then split into 2 to each caliper, Rear have 1 line coming out going to the hydro handbrake then 1 coming out the hydro handbrake then split into 2 to go to each drum.
Your handbrake cable will still work fine along side the hydro one.
You'll have to have the rear line coming thru the bulk head (i brought mine thru just to the side of the servo mount) then have it run across the exhaust tunnel to the hydro handbrake then up over the rear bench then split it in 2 just before the spare wheel well then have them going thru the floor at either side of the boot.
Have a look at Oli (DH DEV) thread, the rear lines are pretty neat on his.

Rich