View Full Version : Big job fittin webber t40s???
radicky
26-12-07, 03:14 PM
will they fit onto a gte? they origonally came off a 94 1.6astra
with mods to your fuel system
yes
No not really... The list is
DHLA/DCOE 40's
Throttle Cable ?10ish EBAY
Throttle Cable Linkage Likely to come with Carbs . if not they're about ?50 from Ebay. get a double Linkage, then you can run two cables or one ! I run one Cable on a double linkage.
Inlet Manifold Mangoletsi Round Port Manifolds for the GSi/GTE are about ?140 NEW. They Come with O Rings and Bolts with Spring Washers.
Alternator Lowering Bracket Will come with the Inlet Manifold
Longer Alternator Slider Can be made from Two Nova Sliders. not Technically neccessary though, i don't have one
Fuel Pressure Regulator ?60ish. FSE do a Good injection one. Reduces fuel pressure from 40Psi down to the 3-4psi needed, Depending on carbs
Trumpets Likely to come with your carbs
Filters/Airbox Likely to come with your carbs. Twin K&N Pancakes are about ?80 !
Then After that, you'l need to..
Block the EGR Valve
RR TUNE + SETUP Under ?100. If you're Northwest. DONT go to Pro-tec !
Remember, If you clean and Paint/Polish up some of your EFi Parts, you can easily make back alot of the money you spend on the New inlet manifold and associated parts.
benthehash
27-12-07, 03:02 PM
yeah i've done mine i'm no mechanic but with help from here it made life easyer!
greg1.4
27-12-07, 03:22 PM
easy job really..you may need to advance the timing slightly.
but when you take it to a roling road they will/should set it all up for you..
check out my nova project to see my novas with twin 40's.
Greg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.