Carb to injection

[nova dosed]

I have got a 1.4sr its camed, 4 brach exhaust kand n (needs setting up though). I wnt to put ijection onto it that way i can get induction chipped etc. How hard or easy is it duz any one know?

Plus ive been told that cause i have a stianless magnex back box on a standard centre section i cnt replace just the centre section with a stainless magnex pmc said it wont fit sumet about the back box not been the right bore is this true and surely i could o[pen up the hole and if it is true why duz it fit my 4 branch

Help

[neiloakley]

why you want injection? I am ripping the injection system off my 2.0 8v cos with a set of webbers on you can get FAR more power out of it.

Save some money and get yourself a set of twin webbers with new inlet mani, set of cams, and get the head gas flowed and compression ration lowered. Then it will be FAST as FCUK

[carltoncrazy]

really making it injection is a waste of time,redoing the ectrics is a pig,
trust i did this to a m8s lx astra,and it was still s**t after

[Dicko]

there is no point in making it injection. lots of hassle and cost. even if u put in a gte engine it will b no faster than wot u have now.
its true that the magnex system will not fit as the system+backbox r designed to fit into each other, different to the backbox alone.
just get the engine tuned u will a big differcne from doing this as they would probably need to rejet ur carb due to the mods u have..