View Full Version : are e16se and c16se inlet manifold,fuel rail and injectors exactly the same?
hiya i have just bought an inlet manifold,fuel rail and injectors for my e16se but the ones i have bought are meant to have came off a c16se and looking at them side to side it looks as though the manifold off the c16se doesnt have a hole in it for a breather at the top like what is on the e16se.
C16se tb, and inlet is different.
Id guess the injectors probably are too, seeing as it uses a different management system.
damn!anyone wanna swap a c16se inlet manifold,fuel rail and injectors for one off a e16se?:( lol
Fit your e16 injectors and throttle body onto the c16 inlet.
i bought it as i was going to send the manifold whats on the car at the moment off for abrasive fluid honing(when i find somewhere that does it:mad: )and the injectors off for cleaning as its my daily driver and i need to use it daily.nevermind i shall stick them up in the for sale section and buy some e16se ones
ive got all the E16SE gear your after :thumb:
i bought it as i was going to send the manifold whats on the car at the moment off for abrasive fluid honing(when i find somewhere that does it:mad: )and the injectors off for cleaning as its my daily driver and i need to use it daily.nevermind i shall stick them up in the for sale section and buy some e16se ones
The inlet will "work", it just wont have the egr holes cast into it, and has a few extra bits, like the air temperature sensor.
Compare the injectors to the e16 ones, they may be the same, but id guess there different as they use a different ecu manufacturer.
ive got all the E16SE gear your after :thumb:
pm'd
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.