View Full Version : xe to let
nova_stee
05-11-07, 11:43 AM
i have a c20xe engine in my shed with no loom or ecu and lots of other bits missing but i have just got a standard set of let pistons, standard exhaust manifold and turbo loom and ecu i also got top hat and some pipes.
i was told i needed to put oil/water (not sure witch) feeds to the turbo so i got this done off some one thats done it before.
so i was wondering if there was any thing else i might need
all comments welcome
ps i am going to pick a eds intercooler and pipes up off a nova to night
nova_stee
05-11-07, 11:45 AM
pps exhaust sorted to
will need to tap an oil feed into the block...
cam's are different..
can use the inlet cam of an xe, but will need a veriner pully so you can fine tune the timing for it
nova_stee
05-11-07, 09:42 PM
i have done oil feed and let exhaust cam sorry for not mentioning these is there out else
cheers
You will need the LET air flow meter and throttle body as well. Also need yellow injectors and 3 bar fuel regulator.
Philsutton
06-11-07, 05:22 PM
the XE's came with 3 bar fuel regulators (well 90% of them)
the XE's came with 3 bar fuel regulators (well 90% of them)
Only ones i've had that did were the dispack ones. All the dizzy ones I have had have had 2.5 bar regs.
Philsutton
06-11-07, 07:58 PM
must be unlucky then, only ever seen one 2.5 bar reg an that was one that I bought off ben ages ago. Ive dismantled hundreds of c20xes and they have all had 3 bar reg on
GRUNT 16V
07-11-07, 12:30 PM
2.5 bar reg up to a certain chassis then a 3 bar reg onwards and have also seen loads of xe's running cream injectors with a 3 bar reg(that are standard)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.