View Full Version : Can i grind....
this bit off the T/B....not entirly grind it off, just make it smaller so i can fit my spunky strut brace...
http://i80.photobucket.com/albums/j181/mikenova/Picture038.jpg
Enlighten me people :D
Mike.
Isn't that the idle adjuster / mixture screw or whatever ???
Sure you'd be able to trim it back a little, best bet would be to remove the screw and see how deep it goes, as long as you leave enough thread for the screw / adjuster then should be ok. (make a note of where it was set to)
Rich
Matt2107
26-10-07, 01:23 PM
I have rights to that picture thanks.
Just kidding. :D
craig green
26-10-07, 02:11 PM
Grind away! The idle screw is next to it, I bored out the bit you circled for a dump valve.
Grind away! The idle screw is next to it, I bored out the bit you circled for a dump valve.
So in theory i could pretty much take it back down to erm, a stump lol
LOL @ Matt :thumb:
craig green
31-10-07, 09:26 PM
Yeah I beleive so.... or smooth it away totally. I've got a spare TB or 3 if it goes wrong.
kewl, yea ive got two TB's so i have a second chance lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.