converting a 1.4spi to multi point some help/advise please

[Steve0011]

at the moment i have a 1.4spi engine and i was considering putting the multi-point injection on (i have access to the the system from a GTE).

could you please tell me whats involved and wether the GTE system would work ok

thanks

steve

[Stuart]

head, inlet, fuel system, MPI fuel pump, lamda sensor if fitted (that means the exuast too, ecu..... would be easier and better to put a 1.4sri engine in

[Adam]

The gte system is also designed for a 1600, so will overfuel on a 1400

[Steve0011]

spi has lamda sensor if im right

could i not change the fuel injectors on the 1600 set up?

more ideas please??

looking to do this as cheap as poss

S

[Adam]

Its much easier to go raid a scrappy, and got the entire top end off a 1.4mpi tbh.
As its a better system, and mapped for a 1400

[Steve0011]

thanks

[stb114]

itll run but wont run right been there done it lol to many flat spots better to swap engines m8

[Steve0011]

itll run but wont run right been there done it lol to many flat spots better to swap engines m8

or just keep the block and swap everything above the head gasket?

Steve