View Full Version : converting a 1.4spi to multi point some help/advise please
Steve0011
11-10-07, 05:36 PM
at the moment i have a 1.4spi engine and i was considering putting the multi-point injection on (i have access to the the system from a GTE).
could you please tell me whats involved and wether the GTE system would work ok
thanks
steve
head, inlet, fuel system, MPI fuel pump, lamda sensor if fitted (that means the exuast too, ecu..... would be easier and better to put a 1.4sri engine in
The gte system is also designed for a 1600, so will overfuel on a 1400
Steve0011
11-10-07, 08:07 PM
spi has lamda sensor if im right
could i not change the fuel injectors on the 1600 set up?
more ideas please??
looking to do this as cheap as poss
S
Its much easier to go raid a scrappy, and got the entire top end off a 1.4mpi tbh.
As its a better system, and mapped for a 1400
Steve0011
12-10-07, 08:56 AM
thanks
itll run but wont run right been there done it lol to many flat spots better to swap engines m8
Steve0011
12-10-07, 10:23 AM
itll run but wont run right been there done it lol to many flat spots better to swap engines m8
or just keep the block and swap everything above the head gasket?
Steve
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.