View Full Version : anyone know if!!!
well today i went to take off the bump strips on the side of the gte.
to my amazment someone had fitted them with tiger bond.
now what i would like to know is will a toffee wheel get the crap off?
should do...gets most things off
Tiger seal is a **** of all things tho, might take the paint with it
Tiger seal is a **** of all things tho, might take the paint with it[/quote]
tell me about it..:roll:
ifit does take paint i'll have to have it blown over with rear arches:D
kevster
06-10-07, 09:36 PM
yead sould do mate , try a heat gun first not for to long tho )
thanx kev will try that..
all ideas are welcome.:thumb:
use hair dryer to warm it up much safer then spray some auto glym tar n remover on leave for about 5 mins
should come off easy if not try thinners
kevster
06-10-07, 10:02 PM
dont use thinners !!!!!!! lol cant fu1k the lacker up like birds crap dose , seen it at the paint shop were little boy racers have taken there 1.1 off with it , but i think that may beause they used shed loads lol lol nnobers lol
Warm the tigerseal up, and peel/scrape it off.
Then clean the rest with tar remover etc.
It is very hard stuff to remove tho
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.