jiffy bag of bolts and nuts

[philly]

require the following bits and bats please. let me know either in here or via pm :D

heater knobs in red, all 3.

time clock with white face if possible if not black face and also the plug for it and a few inches of the loom for it.

2x grub screws that are from the brake discs.

all the bolts from the 2 front wings.

1 from the bottom connecting to the sill.
2 from the inside in the footwell
1 connecting to the front crossmember jus below the headlight
2 connecting the bottom of the wings to the bottom of the crossmember
6 from along the top of the wing

both sides, 24 in total.

1 spacer that is used with the bolts that connect the bottom of the strut arm to the hub. see pic.
http://s49.photobucket.com/albums/f260/plip_plop/other%20pictures/?action=view&current=missinspacer.jpg (http://s49.photobucket.com/albums/f260/plip_plop/other%20pictures/?action=view&current=missinspacer.jpg)

2 nuts holding the master cylinder to the brake servo

Rubber washer from vacuum pipe on the servo.

2 washers from the top of the drivers side engine mount

2 nuts from the top of the drivers side engine mount.

[stb114]

ive got 3 red heater knobs plus the headlight 1 but thats slightly faded cheers

[raymond]

i may hava all the wing bolts mate and the ones from the servo

will have to check though and make sur none are missing :thumb:

[craig green]

All of that (except servo pipe seal) is available from a hardware store/bodyshop.

I have heater knobs in red btw.