View Full Version : tracking help
ianwood
17-05-02, 11:59 AM
i've noticed my car was pulling to the left on acceleration so i stuck it on the ramps and noticed that my toe settings we're out but i've run in to problems i can't get the lock nut to back off cause the threads are rusted i've tried brut force and wd40 any other suggestions :(
take it to a garage to get it done, then if they break anything its there fualt :)
bloke who did mine used a spaner, and a very long extension bar over the end, some WD40, and alot of noise, swearing, sweat.
have u tried all of those yet ;)
ianwood
17-05-02, 12:27 PM
definatly alot of swearing and sweat i'll try the long spanner because i well skint at the moment;)
Use a blow torch on the nut to 'gently' heat it up, being careful not to heat up the thread in the process.
Toby
ianwood
18-05-02, 09:09 PM
as advised i heated up the nut and guess what it worked :) cheers guys for the advice
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.