View Full Version : De-seamed rods
worth the hassle on a 1600T engine?
concidering it only takes half hour to do i would say it was worth it
i may aswell do it then TBH, can check all the piston rings out and add ARP rod bolts at the same time i suppose
your best mate burgo may happen to have some arps ;) and how are you planning on deseaming them?
your best mate burgo may happen to have some arps ;) and how are you planning on deseaming them?
Ahh kewl :D
De-seaming will be a mixture of 6" grinder and a file for finishing off me thinks lol
fooking grinder lol whats your name baxter lol id recommend a dremel
grinder will take seconds lol just mount the Rod in my vice, and away i go lol then finish with a nice meaty file :thumb: sorted lol
sorry to hi jack but what do you get out of de seaming?
is it sort of balancing?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.