View Full Version : 20xe Into 1.5d Nova
KITT1972
16-08-07, 04:30 PM
Has Anybody Done This Before. I Will Be Ok With The Mechaniacal Side Of ThiNgs Ie The Engine Mount Etc. Not Use About The Loom. Can I Use The Same Loom Or Am I Going To Need A Gsi Or Gte Loom?
HopefullY I Can Still Use The Same Loom
If You Can That Would Be Grat
Thanks
General Baxter
16-08-07, 05:05 PM
tbh, id get a complete petrol loom
The Td one is all over the place, with built in relays, and fuses.
KITT1972
16-08-07, 05:50 PM
I Was Thinking The Same
Can Get A Mk1 Loom
Is There Much Dirrenece Between Mk1 And Mk2 Loom
Clocks, hazard switch are all i can think of.
Oh, and a newer mk2 loom will have fuel pump wires, and a few more fuses in the fusebox.
Clarky_man
16-08-07, 07:07 PM
doesnt the engine mount in a different place on a td nova?
Clarky_man
16-08-07, 07:27 PM
so it wont be an off the shelf conversion mount job then?
Nope.
Needs the chassis leg modding to suit a normal petrol mount, and then a 20xe conversion mount.
General Baxter
16-08-07, 08:05 PM
kitt, see here for mount diffs
http://www.pngclub.com/forum/showthread.php?t=84765
chop the engine mount bracket off a petrol nova,make sure you measure exactly where it is on the chassis leg then weld it onto your chassis leg. you changing the fuel tank and lines for petrol? i bought a gsi fuel tank and used an intank fuel pump off a 2.0 ecotec,and flushed my old diesel fuel lines out with petrol
KITT1972
07-09-07, 03:07 PM
anymore help on this
KITT1972
07-09-07, 10:51 PM
No one else with a van then
ReeceH pretty much summed it up.
What else do you need to know?
KITT1972
08-09-07, 08:54 AM
How Do I Modifiy The Diesal Loom Coz There Are Lots Of Relays Under The Dash?
General Baxter
08-09-07, 09:03 AM
id say fit a petrol one, as on the diesel loom, theres wires all over the place, there 6 just to open the therostate lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.