VIBE spares?

[Stanley]

I need a new amp for teh my VIBE CB100 (single 10" amplified sub box) as it was out of a rolled vehicle and has pulled the earth mounting point off the amp and consequently mullered it.

Any ideas?


Im goin to try solder it but im not holding out any hope to be honest, its fecked!

[Welsh Dan]

Can you post a pic of the damage? Its probably solderable, aslong as there is enough track/pad to solder to.

[bump]

Get a photo up, pad / track damage is easily repairable.

[Stanley]

Its a bit of a mess TBH but here ya go.

You can see the earth cable mounting point has been ripped out from the front -
http://i80.photobucket.com/albums/j199/stan_the_man87/DSC00669.jpg

And has made a sizeable hole in the amp curcuit board itself -
http://i80.photobucket.com/albums/j199/stan_the_man87/DSC00670.jpg

Gonna try solder it when i get the notion.

If thats a no-go then il just sell the sub and box seperate.

[Welsh Dan]

Looks doable that mate.

[bump]

That's a relatively easy repair, get a scalpel with a new blade for scratching back, solder up the three cracked tracks then use some araldite to isulate and stiffen the board. In your case use it on both sides.